What's going on in your shop?
- Thread starter Justin Presson
- Start date
Edwardshandmadeknives
Well-Known Member
Winter time here in Minnesota. I don’t have anything going on to post.
I hope to have some new stuff to show off soon. I got some super rad things coming up. Thanks for sharing JesseGot a double clamp plate quench set up for my 1x4x30 aluminum quench plates.
Got a Dry Ice/DNA slurry tray made up for a sub zero treatment of blades that don't fit into my LN2 dewar.
Upgraded Dremel Mill to be much more rigid with a new linear slide table:
Nice and clean cuts 1/16" and 1/8" wide!
Magnacut FBBO smaller size, yellow pins, liners and lanyard tubing, OD green/Burlap handle scales. Yellow Kryptek sheaths for pocket carry and horizontal carry
Had some 1/16" x 5.3" x 1" cutoffs, so I tried making a super thin/slicey scapel! Gotta do more handle shaping, sheath and sharpen to see how it holds up!
Got a Dry Ice/DNA slurry tray made up for a sub zero treatment of blades that don't fit into my LN2 dewar.
Upgraded Dremel Mill to be much more rigid with a new linear slide table:
Nice and clean cuts 1/16" and 1/8" wide!
Magnacut FBBO smaller size, yellow pins, liners and lanyard tubing, OD green/Burlap handle scales. Yellow Kryptek sheaths for pocket carry and horizontal carry
Had some 1/16" x 5.3" x 1" cutoffs, so I tried making a super thin/slicey scapel! Gotta do more handle shaping, sheath and sharpen to see how it holds up!
Attachments
PolishAvenger
Well-Known Member
Starting to get warm enough in the NW to spend some time out in the shop.
Finishing up a deer knife for my brother...just needs an edge. Finish isn't too precious...gonna get used hard.
Finishing up a deer knife for my brother...just needs an edge. Finish isn't too precious...gonna get used hard.
