What's going on in your shop?

I’m sad to see this forum slipping away.
Here is a new flipper from my shop.

Jesse Latham said:

I’m sad to see this forum slipping away.
Here is a new flipper from my shop.

Click to expand...

Winter time here in Minnesota. I don’t have anything going on to post. I hope to have some new stuff to show off soon. I got some super rad things coming up. Thanks for sharing Jesse

Been super cold here too and busy with my normal job. Going to have more posts soon though!

Got a double clamp plate quench set up for my 1x4x30 aluminum quench plates.

Got a Dry Ice/DNA slurry tray made up for a sub zero treatment of blades that don't fit into my LN2 dewar.


Upgraded Dremel Mill to be much more rigid with a new linear slide table:


Nice and clean cuts 1/16" and 1/8" wide!



Magnacut FBBO smaller size, yellow pins, liners and lanyard tubing, OD green/Burlap handle scales. Yellow Kryptek sheaths for pocket carry and horizontal carry


Had some 1/16" x 5.3" x 1" cutoffs, so I tried making a super thin/slicey scapel! Gotta do more handle shaping, sheath and sharpen to see how it holds up!

Reshaped/Contoured the handle on the little one, down to 2.2oz for the knife. Sheath brings it to 3.6 oz! 2.75" cutting edge and 7" OAL.

Starting to get warm enough in the NW to spend some time out in the shop.
Finishing up a deer knife for my brother...just needs an edge. Finish isn't too precious...gonna get used hard.

Finished this one up and now on the way to NC