Sorry fellas, I haven't been back for a couple days. Thanks for the replies. I remember when (believe it was Adam Michael) produced the work rest that Ken was referring to and they were being sold for around $400+. Very robust and well made. I was on his site (quite) awhile back and wasn't...
I have looked at it as close as I can. I was interested in its ability to lock in place and if there was any give to it. If it is a solid unit, it will be my next purchase for sure.
Hello everyone, I'm currently thinking about getting/ making a 20 ton pin press for pressing the pin stock on my bolsters. Here's how I've been doing it. I've had mixed results. Currently I prep the bolsters as most do. I glue (epoxy) the bolsters in place...holes for pins pre drilled. I set...
Hey everyone, I have only done a couple kydex sheaths. Thought they turned out ok. The knives I did then for had bolsters, wich didn't seem problematic. I would like to do one for a small Skinner that has a finger guard. I googled kydex sheaths and didn't notice a sheath made for a knife with a...
I agree...CPM D-2 is my personal favorite! But I'm also enjoying the carbon steels. My understanding of cryo is that it completes the martinsite transformation. These steels are expensive in comparison. My thought on that is if you don't do a sub quench then your not getting your money's worth...
The stock I have came from Also's, I just finished an upsweep Skinner. Its 3/16ths thick.It has a full flat grind with a final edge thickness of 10 thousands. I normally dont go that thick for a Skinner but that's the thickness I had. It was normalized 3 times starting with 1600 then down to...
Thanks for the replies...I had almost given up on a response. I've recently started playing with the carbon steel as the stainless can be very expensive and as of right now I do not have a cryo tank to sub quench. Cpm D-2 only requires a - 100 follow up. I have worked with O-1 a little.I would...
Hey everyone, I've never really used 1084. I make hunting knives primarily and usually use CPM D-2. Now I know I am not to expect the same performance, but wondering what I could expect for that particular use. Given that its heat treated correctly. Can I expect the edge to last through a white...
Well I finally came to my senses and purchased some parks 50 and AAA. I know it's been asked more than a few times " where do you buy parks 50?". I went through heatbath. They were very respectful and polite. My worry was how much I would spending on shipping. The lady at heatbath gave me a...