nthe10ring
Well-Known Member
I have been forging and filing blades for some time but just recently built the Grinder In A Box
with variable drive, everything runs out smooth and I had a few old belts from a friend of
mine till I ordered some belts. Just put some new Gators and Blaze on there and they cut
great but seem to bump side to side . The belt tracking adjusts fine just when its
running its constantly bobbing side to side some. Is this this just the nature of the beast on
new belts or could there be some other problem. I did notice this was not that evident on
the old belts. Any advice or information would be appreciated.
Thanks
Jerry
with variable drive, everything runs out smooth and I had a few old belts from a friend of
mine till I ordered some belts. Just put some new Gators and Blaze on there and they cut
great but seem to bump side to side . The belt tracking adjusts fine just when its
running its constantly bobbing side to side some. Is this this just the nature of the beast on
new belts or could there be some other problem. I did notice this was not that evident on
the old belts. Any advice or information would be appreciated.
Thanks
Jerry