Ray
Dealer - Purveyor
I am not a dealer/purveyor. I am a retired knife maker and I'm clearing out materials.
Nearly have all of the handle materials cleared out. This is the nickel bars and sheets I had left. Use for bolsters, pommels, and decorative spacers. I went to Jantz Supply and priced these out using the price per inch on theirs. It came out to $132.15 for the whole pieces listed below. I didn't price in the smaller stuff.
Asking $75 plus shipping. These will have to go in a medium flat rate, so the shipping cost is $15.05.
Bars.
1/4 inch thick X 1 inch wide X 5 1/2 inch long bar.
1/4 X 1 X 9 inch bar.
1/4 X 7/8 X 3 1/2 inch bar.
3/8 X 1 X 4 inch bar.
1/4 X 3/4 X 6 1/4 inch bar.
3/8 X 3/4 X 8 1/4 inch bar.
Sheets.
0.20 X 6 X 12
0.125 X 6 X 12
0.020 4 1/2 X 10 1/2
And I'm putting in some miscellaneous small pieces too small to bother measuring but still useful.
Nearly have all of the handle materials cleared out. This is the nickel bars and sheets I had left. Use for bolsters, pommels, and decorative spacers. I went to Jantz Supply and priced these out using the price per inch on theirs. It came out to $132.15 for the whole pieces listed below. I didn't price in the smaller stuff.
Asking $75 plus shipping. These will have to go in a medium flat rate, so the shipping cost is $15.05.
Bars.
1/4 inch thick X 1 inch wide X 5 1/2 inch long bar.
1/4 X 1 X 9 inch bar.
1/4 X 7/8 X 3 1/2 inch bar.
3/8 X 1 X 4 inch bar.
1/4 X 3/4 X 6 1/4 inch bar.
3/8 X 3/4 X 8 1/4 inch bar.
Sheets.
0.20 X 6 X 12
0.125 X 6 X 12
0.020 4 1/2 X 10 1/2
And I'm putting in some miscellaneous small pieces too small to bother measuring but still useful.
Last edited:
