New forge

I was thinking about one of these for a blower they also have a 3" that's 130CFM. Nice thing is their DC so putting a control on to adjust CFM would be easy and, I could transport and use a 12VDC battery to run it too. I have a tendency to over think things! LOL!!

Oasis Marine in-Line Bilge Boat Air Blower 4 inch 12V Exhaust Fan (2 Year Warranty) https://a.co/d/hZcQUae
 
Gliden07 said:
I was thinking about one of these for a blower they also have a 3" that's 130CFM. Nice thing is their DC so putting a control on to adjust CFM would be easy and, I could transport and use a 12VDC battery to run it too. I have a tendency to over think things! LOL!!

Oasis Marine in-Line Bilge Boat Air Blower 4 inch 12V Exhaust Fan (2 Year Warranty) https://a.co/d/hZcQUae
Click to expand...
Overthinking things would be using the compressed propane to run the blower before it goes to the burner. :)

12VDC wouldn't be a bad way to go. especially for a travel forge.

Sent from my Champion Forge using Tapatalk
 
Last edited:
Just as a test when Atlas Forge came out with their blown forge using that setup, I ordered a similar setup, rigged up a 3/4" blower tube and darn if it didn't work good. A small 12v battery is all it takes. With the proper sized burner tube it doesn't take near as large a blower as most folks think. All at a cost of less than $20 for the blower and speed controller (at the time)
 
Last edited:
You must log in or register to reply here.
Back
Top