Jeff Conti
Well-Known Member
I just unwrapped a .125 x 1.5 x 18 piece of 154CM, laid out my knife, sat down at the band saw and while cutting through it found my blade unable to proceed forward (like it had run up against something super hard) and then it pushed through (cutting normally again). This happened about 4 times. On the 5th time my blade snapped.
This is a first for me. Any advise. Is this common? Should I send it back to Jantz? I did send them an email. I still have to finish cutting out this knife and then another from the same bar. I suspect my sander is going to have problems too.
This is a first for me. Any advise. Is this common? Should I send it back to Jantz? I did send them an email. I still have to finish cutting out this knife and then another from the same bar. I suspect my sander is going to have problems too.