I have 3 sets of CPM154 blade & springs for slipjoints that I will be sending out for heat treatment. I will most likely be sending them to Peter's HT.
I am trying to figure out what target hardness to specify for the blades and springs. From what I've read on this material I should also specify a cryro treatment.
For the blades, I was thinking 59rc-60rc.
For the the springs, I was thinking 46rc - 49rc.
This is my 1st time using stainless and was hoping for recommendations from those with more experience using CPM154.
Thanks
Jim
I am trying to figure out what target hardness to specify for the blades and springs. From what I've read on this material I should also specify a cryro treatment.
For the blades, I was thinking 59rc-60rc.
For the the springs, I was thinking 46rc - 49rc.
This is my 1st time using stainless and was hoping for recommendations from those with more experience using CPM154.
Thanks
Jim