Recent content by buckaroo

Thank you for the information. I said air quenching but will be using plates. Brandon0403 did you cryo the blade to get 58/59 hrc or just plate quench and temper?

I am getting ready to HT some 12C27 blades. My question is can I air quench this steel or is it strictly an oil quench steel. Thanks, Dave

Thanks for the reply Ken. I had read of people doing multiple blades per pouch. Wondered if it was a good idea.

Thanks for the reply.

I am getting ready to heat treating two blades that are 154cm. My question is can I double stack them in one stainless steel envelope?

High carbon or stainless blade?

No small children around so no problem there. The bottles are marked. They were not marked in the photo because it hard to wright wearing by full bubble wrap suit.

Thanks everyone for the input. I have watched Nick's videos on sanding. They have been a great resource. I also will give the oil a try. Dave

Having a hard time not getting fish hooks while hand sanding. Any tricks to share? Thanks Dave

I use these old soda bottles to store and dispense my WD40 and windex. No more over spray. Tube is from the Wd40 can.

Thanks for the fast replies. I was getting flint and ferro rods mixed up.

Will a ferro rod spark on all knife steels or only High Carbon.

Here is a good video from ARCustomKnives using a motor brush. http://youtu.be/Cf4FfjmMcTw?list=UUGTRbXIkgnnse5SZN9bcAog

Thank you.

Thanks Doug. The information is helpful. M2 is hard to find. Alpha is the only supplier I could find in small amounts.