Erdbeereis
Well-Known Member
Do any of you guys use zirc belts for handle shaping? Do they last longer than alox? I can get them for the same price, that's why I'm wondering.
Do any of you guys use zirc belts for handle shaping? Do they last longer than alox? I can get them for the same price, that's why I'm wondering.
it depends a little.
is the material Wood or g10/micarta?
I've been wondering about where to get open coated 2x72 belts after trying a piece of coarse open
coated paper on my disk grinder and being amazed at how well it cleaned up stabilized wood blocks
back from WSSI as well as how long it lasted.
Do you carry open coated AO belts in, say, 40-80 grit?
I would pass myself on A/O belts from Ace. Unless they are 3M brand, Then depending on cost they may work out fine.
I get my A/O Hermes belts from Tru-grit. Not sure if Boss dog carries those or a equivalent?
Laurence
www.rhinoknives.com
How are Klimgspor AlOx belts?