opaul Well-Known Member Aug 8, 2018 #1 7-5/8" OAL, 15N20 steel, 3-1/4" blade with etched flats, ferric acid patina. This one is going to end up in Ohio.
7-5/8" OAL, 15N20 steel, 3-1/4" blade with etched flats, ferric acid patina. This one is going to end up in Ohio.
Kevin Zito KNIFE MAKER Aug 8, 2018 #3 Very nice blade! I’ve been working on a design that’s similar.... looking good!
BrandantR Well-Known Member Aug 9, 2018 #5 Another nice one, OP. I've always wondered about 15N20. I have a stack of thin stock but have never used it. How well does it hold its edge?
Another nice one, OP. I've always wondered about 15N20. I have a stack of thin stock but have never used it. How well does it hold its edge?
opaul Well-Known Member Aug 9, 2018 #6 I was actually able to get it in 1/8”. I’ve read it does great but I haven’t used it enough to know. But folks who have are big fans. It takes a wicked edge.
I was actually able to get it in 1/8”. I’ve read it does great but I haven’t used it enough to know. But folks who have are big fans. It takes a wicked edge.
