F
Fitz
Guest
Is 3/16'' aluminum thick enough for a set of quench plates(for cpm 154) or does it need to be closer to .250.
Andy
Andy
Excuse me for butting in. Where did you guys buy these large plates? Does it matter what alloy of aluminum, i.e. 5052, 6061, etc?
Thanks Tracy & David. One more question if you don't mind. Can you bolt two plates together to get the 1" or 1.5"? For example, 2 pieces that are .5" each or 2 pieces that are .75" each. I haven't calculated it out but I am guessing that might lower the price a bit?