I could use some advice after an obviously poor decision. Bought some CPM 154 from Boss. Cut into big rectangles with a bandsaw. Profiled on the bench grinder. I felt like I may have overheated it in the profiling, so I decided to anneal it. Did not think about needing to use the SS foil. OOH man, bad surface oxidation, warped beyond my wildest expectations. So I straighten and take the (8) blades to the platen to try to fix them. Burned up several 50 grit blaze belts and am not happy!!! How do I get this oxidation off without spending more in belts than the steel is worth?