Large Clip Point

[SYD32]

Largest knife I have made yet. 5 3/4 inch blade hollow ground from 5/32 CMP 154 bar stock. Handles are ironwood with a stainless bolster and red fiber spacer. overall length is 10 5/8 inches. In hindsight I should have put the forward mosaic pin in a little higher on the handle....



Thanks for looking!

 

[Doug Lester]

It looks like a very outstanding job. In the first picture the front pin looks like it could be about half it diameter towards the back of the handle but it looks fine in the third and forth pictures. It could have just been the angle of the shot that through the appearance off.

Doug

 

[Ausbrooks]

Nice work- I like the bling of the high polish blade and nicely finished ironwood and your grinds look great- keep it up.

 

[TacticallySharp]

I like the choice of pin design. It does not compete with the design of the knife. A lot of knives I have seen lately take the pins to far.

Very nice!

 

[bootstrap]

Good job! Keep it up!

 

[Lagrange]

I like it. The blade design is complimented by the handle shaping. It appears very clean and well fitted. Thanks for sharing.