Grinding out tough angles

[MikeL]

The original thought in this mini cleaver was to make the plunge line match the parallel line of the front side of the blade (see the layout lines). But, I don't see how it can be done. Is it possible? It's a hollow grind using an 8 inch wheel if that makes a difference. Thanks in advance for any advice.

 

[wall e]

Figure a way to hold the knife to match the angle by resting the tip higher is my suggestion.

 

[EdCaffreyMS]

It's difficult, but it can be done. That being said, it would have be be done "freehand", and I would recommend practicing some before you attempt it on the real thing..... it's pretty easy to have a momentary lapse of concentration....and it all go south!

 

[MikeL]

Thanks for the response. Maybe I'll practice on some wood first. I was thinking a smaller than an 8" grinding wheel would be needed.