Folder and locking pocket knife suggestions

R

remist17

Well-Known Member
I am looking to make some pocket knives soon. I would like to know if there are some good books I can get to learn how to make them and the process that goes into making all the parts.
I just picked up Pocket Knife for beginners and it had some really good ideas. The knives in the book are friction knives and I was looking more to the locking blades. I would appreciate if anyone can point me to some reference material.
Thanks
Tim
 
I picked up some of the books mentioned here. Is there any books out there that give you the prints or layouts of the parts? Any words of wisdom on how to start out. I am a little concerned about making some of the parts and the correct sizes.
Sorry for the dumb questions from the new guy!
 
In Don's book I think there are drawings in the back of his books. I also believe some of his prints are sold by USA Knifemaker Supply. You may try PMlng Don and asking him. He has always been very helpful whenever I've asked for advise.
 
Thanks all. I ordered the plans off USA knifemaker.

I am having a hard time understanding one item. I hope everyone does not snicker to loud....
the liners used on folders, I have seen 0.03 up to 0.04" nickel silver material. I am having a hard time sourcing this. Am I looking under the wrong item description. what do I use for the liner on a folding knife?
 
I have read and referenced Bob Terzuola's book "The Tactical Folding Knife" many times, especially the section that describes the geometry of the linerlock. Dan
 
You must log in or register to reply here.
Back
Top