First Liner Lock Since long time

[cardoso5fr]

That project was cursed.... I Began it at the 2009 end. I did 3 blade, 2 liner, 2 scale set.... And each time something went wrong..... I let it 1 year passed after to retry a liner/frame lock.
I did 2 blade for that one because the first was awful, 3 different pivot.... And i won

Finaly that is a liner 11 cm open, 3,6 cm high . 12mm thick. Open 19,5 cm . Sharp 8,5 cm. 2,6mm Thick Blade, 90MCV8 (O2) , full hardening and differential hardening . Flash Tempering.

Ta6V4 liner with 2mm Thick, 100C6 water hardened tang. Stainless screw and pivot, Black G10

Spyderhole Licenced by Spyderco.

 

[jaysmith10]

Good looking piece!!!

 

[Frstr8]

Very nice Ben!

 

[Frank Niro]

It may have been a struggle but it sure looks good!!! Just shows that sometimes doing more than one isn't enough. Frank

 

[cardoso5fr]

Thank you guys. That's right, even if i've already done more or less 15 frame / Liner lock, that one was a pain

 

[dan van]

Looks like your persistence has paid off, looks good. Dan

 

[cardoso5fr]

Thank you Dan