Remy
Well-Known Member
CPM154 Nubilus with redwood burl - Sold
.140 thick CPM154 from Aldo, heat treated by Paul Bos to RC61
7.75" long, 3.9" blade, standard full height double bevels.
Slightly thicker than my normal handles, using Redwood burl from Mark at Itsaburl/Burlsales.com. Scales are nicely shaped, less flat and narrow than many Nubilus without being thick and bulky.
Sheath is equipped with a small Tek-Lok and is secure but not super tight, with a click in fit.
Finish is a very fine scotchbrite for the bevels and bright everywhere else.
This is my first stainless knife using my own blade. I've done a few previously with purchased blades.
$150 including sheath and tek-lok. domestic shipping is $8, international by request.
I'm not sure what's up with the artifacting on the first one along the edge and lower portion of the tang. Camera issue, not knife.
.140 thick CPM154 from Aldo, heat treated by Paul Bos to RC61
7.75" long, 3.9" blade, standard full height double bevels.
Slightly thicker than my normal handles, using Redwood burl from Mark at Itsaburl/Burlsales.com. Scales are nicely shaped, less flat and narrow than many Nubilus without being thick and bulky.
Sheath is equipped with a small Tek-Lok and is secure but not super tight, with a click in fit.
Finish is a very fine scotchbrite for the bevels and bright everywhere else.
This is my first stainless knife using my own blade. I've done a few previously with purchased blades.
$150 including sheath and tek-lok. domestic shipping is $8, international by request.
I'm not sure what's up with the artifacting on the first one along the edge and lower portion of the tang. Camera issue, not knife.
Last edited:
