CPM10v hunter

Shane Wink

Well-Known Member
Darren Sanders and I recently began working with CPM 10v. His offering was sweet and performed very well and here is my offering for a utility/hunter. 4" CPM 10v Rc 64 8.25 OAL .145 FFG with distal taper to tip, textured G10 handle and tang. Swelled Ti throng tube. Very light, stiff, strong and great wear resistance. While I am certain the micarta pinstock will hold more than is needed, future blades will sport micro corbys in their place.

20140621_220955.jpg

20140621_221025.jpg
 

Shane Wink

Well-Known Member
I think the scales need to be a bit more uniform. I like the color contrast but do think a bit more uniformity of the pattern would present better. Any thoughts?
 

calvinthib

New Member
Darren Sanders made one for me about 9 months ago , use it daily and have only sharpened it once , this material will hold an edge forever . very pleased with my purchase. The only downfall is that if not taken care of it will rust. being that I use it on a daily basis I do not have that issue.
 
Top