Couple of skinners...

[bladegrinder]

Here's a couple skinners I recently finished...

This one has a CPM-154 blade with vine pattern filework on the spine, black G10 bolsters, Box Elder burl scales with black liners, nickel silver lanyard hole and nickel silver, brass and red fiber optic pins.

This one has a Alabama Damascus blade with vine pattern filework on the spine, black G10 bolsters, Desert Ironwood scales with black liners, nickel silver lanyard hole and nickel silver, brass and red fiber optic pins. Thanks for looking

 

[tkroenlein]

Those pins are cool!

 

[Randy Lucius]

Those pins are cool!

They sure are! Nice work bladegrinder. Both are great blades.

 

[jmforge]

Those pins are cool!

I was gonna say that those fiber optic pins are kinda funky. Where did you get them?

 

[jmforge]

Here's a couple skinners I recently finished...

This one has a CPM-154 blade with vine pattern filework on the spine, black G10 bolsters, Box Elder burl scales with black liners, nickel silver lanyard hole and nickel silver, brass and red fiber optic pins.

This one has a Alabama Damascus blade with vine pattern filework on the spine, black G10 bolsters, Desert Ironwood scales with black liners, nickel silver lanyard hole and nickel silver, brass and red fiber optic pins. Thanks for looking

Cool. Where in Florida are you?

 

[bladegrinder]

They sure are! Nice work bladegrinder. Both are great blades.

Thanks Randy!

 

[bladegrinder]

Hi JM, I made them by inserting fiber optic rod into brass tubes with epoxy

Cool. Where in Florida are you?
I lived in Clearwater for over 30 years till I retired from my full time job last September. sold my house there and moved up to the panhandle, now I'm living on 30 acres in the deep woods off a dirt road and living the dream, making knives, hunting and playing in the woods.

I couldn't wait to get out of Clearwater, to crowded and to much traffic.