Counter bores?

[Timy]

Trying to track down a counter bore. Looking for a 5/32 pilot, 1/4 hole.

doesnt need to be carbide, its gonna be used drilling canvas micarta and wood.

Appreciate it.

 

[curtisk]

Timy,
I make mine. I start with a brad point bit and grind it back till I get the od I want, like in your case a 5/32. Make sure you leave the brad point on the bit until you get the od behind it that you want. This works wonderfully on wood and synthetics. Curtis

 

[Pelallito]

Here you have some counterbores.
http://www.use-enco.com/CGI/INPDFF?PMPAGE=84&PMCTLG=00
But 1/4 requires a 3/32nd ppilot.
Fred

 

[SBuzek]

Here you have some counterbores.
http://www.use-enco.com/CGI/INPDFF?PMPAGE=84&PMCTLG=00
But 1/4 requires a 3/32nd ppilot.
Fred

Close but not quite right. Buy the 1/4" counter bore and then drop down to the list below it and get a 3/32"shank 5/32" pilot.

Stan

 

[Pelallito]

Stan,
Glad you spotted that. I did not stay on the page long enough to take a good look.
Fred