Another slipjoint question.

Jim Coffee

Well-Known Member
I'm looking for bronze bushings that are 3/16 o.d and 3/32 i.d. all the supply places I have looked at don't show them. Any ideas where I can get some? Thanks for the help guy's.
 

Plas62

Well-Known Member
I had bought mine at Knife and Gun Supply. I just checked their new website and couldn't find the bushings. I sent their customer service an email to see, if they still carry them. They were the only place I could find that carried them when I bought mine. I'll post their answer when I receive it.

http://www.knifeandgun.com/
 

KenH

Well-Known Member
I may have missed them, but smallest ID I saw was 1/8" and Jim is looking for 3/32" ID.

Ken
 

Calvin Robinson

Moderator Christian Forum
I'm looking for bronze bushings that are 3/16 o.d and 3/32 i.d. all the supply places I have looked at don't show them. Any ideas where I can get some? Thanks for the help guy's.
Hey Jim,
When I get to the shop later I'll check,I may have some. I make my own but I quit using them on my slipjoints. What's the minimum thickness you need?
 

Jim Coffee

Well-Known Member
Thanks Calvin. I was going to use 1/8" for the blade so anything wider then that will work.
What are you using for pin stock?
 
Top