All done! First peened tang and makers mark!

believerjoe

Well-Known Member
1095 with 5 inch cutting edge. Stainless guard and pommel. Amber dyed stag handle with micarta. Loving it. Still getting better.
 

Attachments

  • A5333EE8-6C0C-42A6-9CC8-1CE556215F1E.jpeg
    A5333EE8-6C0C-42A6-9CC8-1CE556215F1E.jpeg
    1.5 MB · Views: 67
  • 5F69C1C1-86AA-471C-95C9-AB208BBF507C.jpeg
    5F69C1C1-86AA-471C-95C9-AB208BBF507C.jpeg
    1.3 MB · Views: 70
  • 360175FF-925B-429F-AE4C-A2BCB92A023F.jpeg
    360175FF-925B-429F-AE4C-A2BCB92A023F.jpeg
    1.3 MB · Views: 68
  • 0452FE76-EF1E-4062-A9EE-E1ED853FBFCA.jpeg
    0452FE76-EF1E-4062-A9EE-E1ED853FBFCA.jpeg
    1.5 MB · Views: 63
Start about 4-5 holes above where you ran out of thread and stitch over the thread that is already there and continue on. Just try to snip off the loose ends of the thread as close as possible.

Doug
 
Start about 4-5 holes above where you ran out of thread and stitch over the thread that is already there and continue on. Just try to snip off the loose ends of the thread as close as possible.

Doug

thanks. I actually designed this one to be broken up like that, but I regretted it in the end. I learn something every time, so it will not happen again.
 
Back
Top