After you get your knives back from HT, what are your steps?
FYI I'm using O1. Do you just give it a sanding down to final finish then put an edge on it.
Currently my edges are at .30" - is that the final thickness of where you put an edge on or do you take it down further. If so, what do you take it down to?
Thanks
FYI I'm using O1. Do you just give it a sanding down to final finish then put an edge on it.
Currently my edges are at .30" - is that the final thickness of where you put an edge on or do you take it down further. If so, what do you take it down to?
Thanks