A couple of new linerlocks..

bladegrinder

bladegrinder

Well-Known Member
Here's a couple Liner Locks I recently finished.
this first one has a blade of satin finished CPM-154 with jigged bone and African blackwood, jeweled a and anodized titanium liners and ti-thumb bob, stainless screws.

IMG_0209_zpsy01gsmzp.jpg


this second one has a Alabama Damascus blade, blue stabilized Masur birtch with white micarta bolsters, the bolsters having scrimshaw of a bighorn sheep on one side and a mountain goat on the other,jeweled and anodized titanium liners and ti-thumb bob, gold plated screws.
these both have polished stainless back bars with vine filework but I didn't get pictures of that. thanks for looking...

IMG_0204_zpsv1bwduyx.jpg

IMG_0205_zpsbrdhhyme.jpg
 
Thanks Calvin, the scrim was done by Jimmy Smith, "Smittys Designs". He's vice President of the Florida knife makers Association. he does great work.
 
A couple of very nice knives. Nice choice of materials and craftsmanship. You're a true artisan.
 
Both are great! The wood on the second one really draws my attention, great choice. I wasn't even aware you could engrave/scrimshaw micarta, pretty neat.
 
I wondered about that too before. none of the scrimshanders I've spoken with seem to have any problem with it. I know there are different grades of micarta floating around out there, I have seen some that I don't think would scrim good. the micarta on this knife is paper based and really came out nice.
 
You must log in or register to reply here.
Back
Top