It slides perpendicular to the blade and leaves a slight gap. I can't figure out anyway to tighten it so I figured I would just apply some JB Weld to it and hope for the best. Ya'll got any other suggestions?
I've got a few decent face masks left over from leukemia
I went ahead and bought an extra slice of micarta. I know I'll either screw up or when i get done i will think of something I want to change
Great idea! I didn't think of that.
I seem to have misplaced the screws I was going to use...
I decided I want to learn a bit more. I've picked up some micarta and decided I want to make new scales for one of my knives (a well used Buck/Strider). With my limited knowledge, I have determined the steps I am going to take.
1. Make outline of knife and attach to the micarta block
2. Using...