Recent content by SYD32

I've used the oven cure (H-Series) Cerakote on some knives I've made previously, but wanted to try it on a rifle. Took me a few minutes to get over the though of sandblasting a nearly new S&W M&P 15X but it had to be done. Took quite a while to sandblast all of the parts down to bare metal...

Thanks!

I've tried to search for some information on Heat treating CPM S35 VN but have had some difficulty finding results. My question is, is the heat treatment for CPM S35 VN the same as it is for S 30? thanks in advance!

I've been working on these three knives for the last two weekends. Finally have them finished! #1 CPM 154 Mirror Finish Dyed Yellow stabilized Box Elder Burl Mosaic Pins File work along handle Nickel Silver Bolsters #2 CPM 154 Mirror Finish Stabilized Maple Burl Mosaic Pins...

#3 for me.

Rudy, I tried your technique with he t-shirt and nail. The mark came out much clearer and cleaner however I can't seem to get it as deep as I would like. I was using the personlalizer plus set at the maximum setting of 5 when I did the etch phase as well as the mark phase. Thanks again...

Thanks for the information. I will be etching a knife tomorrow and will post the result.

I know this topic has been addressed before but I can't find it in my searches. When I etch my maker's mark on a knife I use a stencil from Ernie and a personalizer plus. I always use blue painters tape to keep my stencil flat an the blade. I use the felt pads that came with the machine as...

Here is one I just finished today. Blade is hollow ground from CPM-154 1/4 inch bar stock and mirror polished. The blade is 5 1/4 inches long and the overall length of the knife is 10 inches. Stainless loveless bolts hold the polished linen micarta scales on to the full tang. The scales are...

I own a TW90 and absolutely love it! I have looked at the surface grinding attachment but haven't made the purchase yet although it is on my priority list of future purchases. I would definitely recommend a disc grinder if you don't already have one.

That is a great looking knife. What is the pistol?

Very nice!

I am no pro, but what i do is etch my maker's mark really deep then cerakote over it. Cerakote calls for a thin application and if you etch your mark deep enough it will still be visible.

Awesome!

Thanks for all of the great comments! Yes, the turkey was a Merriams, shot southwest of Flagstaff, AZ.