Sugar Creek Kiln, How To Program?

murphda2

murphda2

Super Moderator and KD Blade Show Boss
Do any of you guys have one of these? I recently acquired one of the smaller knifemaker's kilns. I have the packet which came with it, but there are no instructions on how to program the digital controller. Do any of you have the manual? If so, can you scan it and send it to me?
 
Thanks IG. I didn't think of that. I'll go over to the shop and check it tonight. I'm wanting to say that it is an Orton controller.
 
You can google the orton controllers webpage. I have a PDF copy at work that I could email, but I won't be back in the office until tomorrow. May not be the exact model number as yours, but I think programming is the same.
 
murphda2 said:
Do any of you guys have one of these? I recently acquired one of the smaller knifemaker's kilns. I have the packet which came with it, but there are no instructions on how to program the digital controller. Do any of you have the manual? If so, can you scan it and send it to me?
Click to expand...


Hey Murph,
Sugar Creek uses the exact same Computer Control as EvenHeat has on their kilns, also BossDog has a video on YouTube that gives pretty good details on how to program it, if you still need help, I can call you when I get home tonight and walk you through it, I just need to be in front of mine so I can remember how to do it! Hope this helps, Rex
 
You must log in or register to reply here.
Back
Top