Calvin Robinson
Moderator Christian Forum
I came up with this design just before the blade show but didn't have time to build one untill I got back. The monday after the blade show I started on this and a fixed blade order from the show I finished this yesterday.
This is the prototype for my T-1 modle linerlock. The D-2 blade is 1/8" thick and 2 3/4" long @ 60.4 Rc. The overall length is 6 11/16". The liners are .05" titanium and the bead blasted bolsters are titanium as well. The handle scales are chocolate paper micarta, hand jigged. All hardware is stainless steel.
I hollow ground this blade on a 8" wheel, I haven't used that small wheel in a long time. I ground the false edge on the spine of the blade on the 2" wheel of my homemade horizontal edge grinder.
I'm going to try and build some of these to take to the A. G. Russell Knife Event in a few weeks.
This is the prototype for my T-1 modle linerlock. The D-2 blade is 1/8" thick and 2 3/4" long @ 60.4 Rc. The overall length is 6 11/16". The liners are .05" titanium and the bead blasted bolsters are titanium as well. The handle scales are chocolate paper micarta, hand jigged. All hardware is stainless steel.
I hollow ground this blade on a 8" wheel, I haven't used that small wheel in a long time. I ground the false edge on the spine of the blade on the 2" wheel of my homemade horizontal edge grinder.
I'm going to try and build some of these to take to the A. G. Russell Knife Event in a few weeks.
