Grinding belts

Von Gruff

KNIFE MAKER
I have been mostly using carbon steels so my belt range has been the zriconia belts of 60, 120 and 220 git which has been all that has been necessary and have got them all fromUSA Knifemakers through a forwarding agent. Having started to do blades in 12C27 now I got in a couple of Norax belts from the NZ agent for the Australian knifemaker supplier because they ony take a week to get here and I needed them (now) but they cost half as much again as what I can get them from the US for. I have been using the Norax U264-30 which is about 500grit but I dont see this belt on the USA Knifemakers Norax belt page so what I would like to know from the knowledgable here is what is the equivelent belt going to be or will I have to do a 400 then a 650 grit
 
Back
Top