D6rpf-5

[J. Hoover]

Finished this one recently, it's the Deep 6 Recon Path Finder with a 5 inch blade done in Kirinite and CPM3v. It feels great in the hand and is scary sharp. Scales on this one were attached using stainless 3/16 standoffs and stainless 4-40 machine screws.

Steel- CPM 3v X 3/16
AOL- 10 1/4 inches
HT- In house to a RC of 59-60
Blade- 5 1/4 inches to front of scales with finger choil for precision when required and a skull crusher on the tang for when it's not.
Grind- Flat with drawn unsharpened swedge and thumb jimping on the spine ( scary sharp)
Finish- Hand sanded to 2000 grit then etched for a subdued finish.
Handle- 5 inches
Scales- Desert Camo Kirinite from USA Knife Maker Supply
Hardware- Stainless 3/16 standoffs with stainless 4-40 Torx screws
Sheath- .80 Kydex in Urban Camo set up for large Tek-lok- Multiple carry options, right or left hand, vertical, horizontal, or handle down. Knife clicks into sheath for a secure carry.

 

[Lagrange]

Nice knife. That krinite looks very interesting.

 

[backtines]

Very nice . Looks tough and strong. I like it

 

[J. Hoover]

Thanks guys, I was hesitant about the kirinte at first but it works easily, and finishes out super nice. The pictures really don't do it justice, it has a lot more going on than they show.