This knife is 3/32 CPM 154 with brass liners, canvas micarta, bronze washers, and brass pins. Cut swedges. Backspring is nice and flush at closed and half, slightly low at open. Good medium snap to 1/2 and out, a little less on the closing snap. Gaps on the liners at the front of the knife are from the thin bronze washers I used on the pivot, since I don't have a mill to relieve the liners. No gaps on the washers or pins. Point lays dead center. This is 100% my work, from bar stock. Did the heat treat and dry ice cryo myself as well. I'd like to get $225 for this one, but it looks like it's not happening. Now $200.
And finally, next to a sodbuster junior for a size reference.
And finally, next to a sodbuster junior for a size reference.
Last edited: