kevin - the professor
Well-Known Member
Hello Everyone,
I am new to the forum, and not sure exactly where to post these. I am not quite a newbie anymore, but don't really warrant my own forum.
So, here are a couple of traditional style seaxs that I recently made. The long one is 14" by 1.5, with the spine being twisted 1080 and 15n20 (9 layers). The cutting edge is two bars of 1080.
The little one is from the same billet as the larger one, but with wrought iron welded to the spine.
The handle on both are maple (birdseye for little one, curly for big one).
I hope you enjoy them. Thanks for looking. Comments are welcomed.
Kevin
I am new to the forum, and not sure exactly where to post these. I am not quite a newbie anymore, but don't really warrant my own forum.
So, here are a couple of traditional style seaxs that I recently made. The long one is 14" by 1.5, with the spine being twisted 1080 and 15n20 (9 layers). The cutting edge is two bars of 1080.
The little one is from the same billet as the larger one, but with wrought iron welded to the spine.
The handle on both are maple (birdseye for little one, curly for big one).
I hope you enjoy them. Thanks for looking. Comments are welcomed.
Kevin
Attachments
Last edited:
