Search results

I use peanut oil in a LARGE crock pot that oil is over a year old and it seems fine

Great work

Try putting some more tension on the belt

I find pre HT high speed 60grit, square full passes work for me. I struggle on long blades, I'm currently chasing one. Looks great.

My mother has a condo water front in St Pertersburg yikes, might not be there in the morning. Sending prayers out for ALL.

Very nice, love that handle.

It would take me 2 months to do that much Ed, curious what are you using the 1/2 keg for. I have a few stacked in my shop., looking for a project.

To start with, I dont want to buy both. Im leaning towards the 14" I have only flat ground so far so. I realize 14 gets you a higher grind and more flat but I dont only grind large blades. Im also convinced Im overthinking this, any thoughts??

Vacuum wont trap the tiny debris (most dangerous) to your lungs. I exhaust and replace air, filter air, wet grind kool mist with a water bucket under the platen or wheel. Keep in mind when you vacuum without a water separator, you are second coating your lungs ( after you remove your mask) and...

You will eventually have dust everywhere. I have a 20x30inch filter box 5 filters deep, air changes 12 times per hour I still get dust still wear a mask (a must) I started wet grinding with a kool mist system for the big hogging, then dry for 220 and above I just use water and air. Its not full...

A 20"? I'd have to add another hamster to keep it moving.

Was that from fleabay I was eyeing that one. Im thinking 12 or 14

I use https://www.amazon.com/Resp-O-Rator-Dust-Respirator-Model-JR-7/dp/B002KA0CMO I converted it to use P100's works fine

*****Older thread, didn't see that My setup is on this page, 220V. If I was full time I would spring for the KBAC . I have had NO problems with the TECO I still need to vent it. I have not had any heat issues with it so I'm in no rush...

I tried that packing tape with the cord in it, out of curiosity held at like medium speeds. Not something I would depend on.

AR, I built my own grinder w/VFD being able to slow a 7 down or crank it up when I need it, thats all This week Ill get time to see how my 4 inch wheel works should be fine.

Makes sense Ed, thanks

Thinking of ordering the 7 inch drive wheel, but the torque with @2hp 1740 motor might be to weak at low speeds. Any input thanks

Trenton Thanks copy away, its what I did, took ideas from all around. Im no welder or fabricator but mine turned out fine. My next one will be all aluminum.

Grinder complete Did some upgrades (Im calling it done) 1. 2HP 2. FM50 202c, in case I want to go 3HP later. 3. Remote switch FWD,Rev,Speed. The tool box idea I liked, saw someone post with it on here, Thanks Im building a table (mobile) so I can also grind outside. I made a 25ft heavy...