Search results

DD workrests on instagram

Better than no gas.

Straight CO2 works for mig. It leaves more splatter and the welds don't lay as flat but works just fine and is less money than the mix. I use both depending on the application.

Various holes to be drilled in a folding knife: *Pivot: 1/4" Pivot: Predrill with Letter "D" (.246") bit and ream to 1/4" (.250") 3/16" Pivot: Predrill with #14 (.182") bit and ream to 3/16" (.187") *Stop Pin: 3/32" Stop Pin: Predrill with #43 (.089") bit then ream to 3/32" (.093") 1/8" Stop...

All of the wood I will be offering is K&G stabilized. Nothing less. #1&2 are quilted maple @$15 ea. #3&4 are Curly maple @ $20 ea. Shipping is priority flat rate at cost rounded up to the nearest dollar. Ins is extra if wanted. This is quality wood with only a polish to show beauty.

DDworkrest on IG

Some of you may know or have bought handle blocks from Steve before he passed. He and I had tables at a number of shows together. His wife asked me to sell the remaining inventory. I will start listing blocks after the OKCA show. If you are attending the show, you can find me at tables R-06...

A little over the top trailing point. .210 AEB-L, tang tapered to .040, stabilized spalted Madrone. Don't you hate it when tiny scratches pop up in a photo in a place (ricasso) where it's almost impossible to fix them?

New Koa flipper. Tom Morris damascus. Blade, Ti and pocket clip gunkoted with satin clear. Headed to OKCA.

I also started with known knife steel for the same reason. I do however occasionally grind a complete knife from hardwood for custom builds to make sure it is what the customer had in mind.

This so much. It makes life better. I like your budget!

I put the cork on with contact cement. It might be difficult to get off though. I have one of Nathan's 1 degree discs. It is steel, I figure I can heat it if I need to remove the cork. I use feather disc adhesive for the paper.

I use 1/16" gasket cork.

I have a G0704, pretty much the same except it didn't come with DRO's. Like Bob said they have limitations but within those limitations they're good. The DRO is a must have. I went straight to ER25 collets. No unscrewing the drawbar.

I'll take the small wheel holder. j_klatham@msn.com

Does the small wheel holder include wheels? If so I would like it.

If you haven't watched this before: https://www.bing.com/videos/search?q=alex+snodgrass+bandsaw&docid=607999852578276742&mid=B975EE9BF420EB736BACB975EE9BF420EB736BAC&view=detail&FORM=VIRE This video changed my bandsaw game.

I found some new 2.5" copper pipe at the scrap yard. Cut, split, heated it red and quenched then straightened it.

I have a tendency to agree. One of the things I learned on this project is I didn't start with enough core thickness. The core started as .215, the damascus layers were about the same and the copper was a little over .062.

No, I just etched my name then covered it with nail polish. Thanks