Search results

I would probably put jimping on back but that;s just me

Another tidbit. if stainless I solder from the top but if brass you can apply at bottom and move your heat to the top of guard and it will suck up it to the top. I have a piece of 1/16 stainless wire that I sharpened and use it to drag solder around the guard to make sure it is filled where I want.

Back on Bob Dozier's guard soldering, I use Stay Clean flux with silver solder and my wire is 1/8 round. i take it to my bench block and beat it almost flat. i have maybe a 1/32 edge touching and dip in the flux previous to touch the hot guard. A lot less mess to clean up afterwards. I have a...

Update We are still looking. Those that are on Instagram hit the site and search Oklahoma Knife Group We are posting some of the work by the makers coming to our show! Dang there is some good stuff!!!!

Knife and Gun supply carry an 1/8 rubber disc in 9 inch size. I have a homemade and run 60 self stick on one side and the 1/8 with adhesive spray for 120,220,400,600 and 1000 on the other side.

Super glue them together to profile!

I didn’t think you had worked there enough to get it dirty. Now if you’re offering your services please contact me. My shop has a fine film of everything from the last 10’years plus!!!

We are looking for a photographer for our Oklahoma Knife show on February 25 in Oklahoma City, Oklahoma. We have 52 knife makers setting up at the show. Interested persons please respond to OklahomaKnifeGroup@Gmail.com.

Any one interested in doing knife photography for a show. Oklahoma Knife Group is looking! Any one interested please contact us at OklahomaKnifeGroup@gmail.com The Show is February25 in Oklahoma City, Oklahoma

12 degrees now in Central Oklahoma with wind chill-12 .

fitzo is absolutely correct. I have a couple of carving sets in my drawer that I collected.

The Little Machine Shop has one on sale this week!

The hollow grind removes material faster than trying to just flat grind it.

Easy way to taper. Mark your butt and draw edge line similar to knife edge. Take from guard area and hollow grind with a small wheel to butt. Start your flat grind. I hold verticals and press in on butt to start. Work until you bring it up to guard area.?Repeat on other side. I then go to flat...

Another one for your pleasure. Glen's Burly scales N more on Facebook. Hybrid, stabilized, buffalo horn,rams horn,some stag.

Thank you

Is the usualsuspect forum gone now? I used to check it out but can't pull it up any more.

I don't know who you are asking about.

By vote of the board tonight membership is extended to any person in Continental USA.

Cool Tool II is my fluid.