Search results

You will hear this from almost everyone: "DP bearings are not made for side loading". If you do use one as indicated besides the already mentioned issue it will not last long. The bearings being the issue. I have a Grizzly G0704. I drill more holes with it than with my dp's (2). Beside use...

Thanks for the kind words. Overall length is 12 inches, tip to guard is 6.75 inches. Height is 1.125 inches. The handle back of the guard to butt is 4.875 inches and is stabilized (K&G) black line spalted maple with G10 spacers. Steel is 1080 and 15N20 and started as 9 layers.

Everyone!

I made this knife for the OKCA show which may never happen again. On a recent trip through Cali I dropped it of at Dave Ferry's shop for a sheath. It started as an attempt at raindrop but I wasn't happy with the grind.

That's a defect. Take it back.

Jerrod Todd sells 15n20.

Let me know. Jesse 509-366-6725

I'm not Ken, but 1 ph won't run on vfd.

The lock bar ends up with a spring temper and of course the lock face on the blade is hard. I can't imagine any issue of wear on such a small knife. I thought about carbidizing the titanium locks but haven't seen the point.

I thin and spring temper.

Another couple Pequenos.

These little guys have been keeping me busy lately. I had a request for one in all damascus so I made an extra. My damascus of 1084 & 15n20.

Merry Christmas

Not really. A lot of really great grinders do have 1.5" tool arms. My two Bader III"s have the much maligned 1.25" arms. I've never seen a problem with them, and half of mine are aluminum.

They might make it a pain to clean. I'd probably think about filling them with brass or something. Other than that it's something I've been thinking about making.

A vacuum pot would eliminate that. Perhaps use more epoxy and squeegee the excess from each layer as you add them, trying to eliminate air bubbles.

Someone disrespected him in a thread rather harshly. So he left. I also wish he was still here.

Yes. I ordered last Thursday it's going to be here (in WA state) tomorrow.

Thanks everyone for the leads.

A while back there were mentions of where the best prices were for p50. I haven't been able to find the thread. Do you remember where or who?