Search results

I just ordered the ATEZR P20 Plus. $598 including tax.

For those of you who bought the 10 watt lasers, have you found anything in knife making that makes you wish for the 20 watt laser?

Pretty common on Wa handles.

He sells on ebay also.

Don makes many products. They are first rate. This is what you are looking for.

DD workrests on instagram

Better than no gas.

Straight CO2 works for mig. It leaves more splatter and the welds don't lay as flat but works just fine and is less money than the mix. I use both depending on the application.

Various holes to be drilled in a folding knife: *Pivot: 1/4" Pivot: Predrill with Letter "D" (.246") bit and ream to 1/4" (.250") 3/16" Pivot: Predrill with #14 (.182") bit and ream to 3/16" (.187") *Stop Pin: 3/32" Stop Pin: Predrill with #43 (.089") bit then ream to 3/32" (.093") 1/8" Stop...

All of the wood I will be offering is K&G stabilized. Nothing less. #1&2 are quilted maple @$15 ea. #3&4 are Curly maple @ $20 ea. Shipping is priority flat rate at cost rounded up to the nearest dollar. Ins is extra if wanted. This is quality wood with only a polish to show beauty.

DDworkrest on IG

Some of you may know or have bought handle blocks from Steve before he passed. He and I had tables at a number of shows together. His wife asked me to sell the remaining inventory. I will start listing blocks after the OKCA show. If you are attending the show, you can find me at tables R-06...

A little over the top trailing point. .210 AEB-L, tang tapered to .040, stabilized spalted Madrone. Don't you hate it when tiny scratches pop up in a photo in a place (ricasso) where it's almost impossible to fix them?

New Koa flipper. Tom Morris damascus. Blade, Ti and pocket clip gunkoted with satin clear. Headed to OKCA.

I also started with known knife steel for the same reason. I do however occasionally grind a complete knife from hardwood for custom builds to make sure it is what the customer had in mind.

This so much. It makes life better. I like your budget!

I put the cork on with contact cement. It might be difficult to get off though. I have one of Nathan's 1 degree discs. It is steel, I figure I can heat it if I need to remove the cork. I use feather disc adhesive for the paper.

I use 1/16" gasket cork.

I have a G0704, pretty much the same except it didn't come with DRO's. Like Bob said they have limitations but within those limitations they're good. The DRO is a must have. I went straight to ER25 collets. No unscrewing the drawbar.

I'll take the small wheel holder. j_klatham@msn.com