Hello all. I have a project that must bond metal extremely strongly to carbon fiber/nylon composite and withstand 2000 rpm of spinning stress. I would be grateful of any input from those who know.
Gudday mate. I am no expert but this is what works for me. I only us 1/4 and 1/8 inch pins. So you only need two size drill bis and remers of same size. Drill your holes and ream. The reamer gives a more precise sized hole. Measure your pins with a digital calipper. Check they are correct size...
Thankyou for comments. What happens if you use the metal blade for cutting wood? Is 'bimetal' designed for wood and metal?
Why is a custom blade better?
That is simple and elegant. Sometimes we try to bring too many different elements into the one knife. Very special job.
Question: What is the process to put a shield into the handle? Always been reluctant to try.
I was thinking along those lines. Parts are quite good and other could become a bit experimental. If it is in resin it should be ok too. Another skill to learn. Who ever said knife making isn't a challenge. Thankyou again Ed for you input.
Hi. Just acquired some small pieces of mammoth. I guess it is really mammoth ivory bark. Some is in poorer condition and looks dry. Any suggestions on stabilization or treatment?