Gliden07's latest activity

  • Gliden07
    Took a class today at a friend's forge. Forged in Fire winner Jorden Lamothe taught it!!! What a great class! Learned what it takes and...
    • 388_1555281530127.jpeg
  • Gliden07
    Gliden07 replied to the thread Just wanted to update everyone.
    Glad to hear you and your Doctors have a plan. Hope all goes way beyond well for you!! You need a break!! Prayers, Fingers and Toes...
  • Gliden07
    Gliden07 replied to the thread Just wanted to update everyone.
    Good luck Ed!!
  • Gliden07
    Gliden07 replied to the thread Finally one off the bench!.
    Yes I made a Chefs knife last year this is to go with it.
  • Gliden07
    Gliden07 replied to the thread Finally one off the bench!.
    That's what I was going for!
  • Gliden07
    looks like a worker just sitting there 07. Nice slim design.
  • Gliden07
    Man I've just been flat out since Thanksgiving finally got down to shop and more or less finished this little paring knife. Needs a few...
    • 20190403_204637.jpg
  • Gliden07
    Gliden07 replied to the thread Wrought!.
    Thanks for the advise! Just like this whole journey I'm giving it a shot at some point. Just like always just need the time!!
  • Gliden07
    Gliden07 liked Doug Lester's post in the thread Wrought!.
    Wrought iron can be a chore to work with. Remember to keep it at a yellow heat, almost forge welding heat. Lower grades of wrought...
  • Gliden07
    Gliden07 replied to the thread Wrought!.
    Well apparently 3 out of the 4 pieces are Wroght! Old hand forged hinges. Real neat to look at how the Smith did the Forge welds, I...
  • Gliden07
    Gliden07 liked C Craft's post in the thread Wrought!.
    There is one way to know for sure if it is wrought! Cut half way and bend it. If it looks like this you got a bingo!! The side that is...
  • Gliden07
    Gliden07 replied to the thread Wrought!.
    I was looking at the side and scraped the old paint and dirt off I can see the layers also the ones that were tied together one of the...
  • Gliden07
    Gliden07 liked AkWildman's post in the thread Wrought!.
    If those turn out to be wrought iron you hit the jackpot .I say if they as you never really know till you cut it and bend it open to...
  • Gliden07
    Gliden07 posted the thread Wrought! in Knife Dogs Main Forum.
    Went to an antique store with the GF and found all these hand made wrought iron hinges for 10 bucks!!
    • 20190330_142057.jpg
  • Gliden07
    The only real motors you can use a Variable Speed unless it's a VFD is on a brushed motor, using an accelerometer motor control or a DC...
Top