Recent content by Ga Red

  1. G

    Tapering holes in front Bolster

    How do you taper the hole in the front bolster of a slip joint folder for the pivot pin. I want to tapper for 3/32 and 1/8 pins. When peening the pin do you just tap around the edges of the pin. I hear hitting directly on the top will cause the pin to swell.
  2. G

    8670 steel verses 80CrV2 Steel

    How does 8670 steel compare to 80CrV2 steel in toughness and edge holding at same hardness and blade grind
  3. G

    Reparing Paragon Kiln

    Does any one know where I could get my paragon Kiln fixed or repaired close to Valdosta, Ga or would I be better off to send it back to Paragon
Top