EdCaffreyMS's latest activity

Thanks Alden! You'll be there before you know it. ;)

The Specs are: -All Titanium scales, clip, and screws/hardware -Caged Bearing Pivots -Blade: 80CRV2 (Flat grind with convex edge) -Blade...

I've been working on this pattern design, and tweaking for a long time, trying to find what I consider the right mix for an Ultralight...

Counter Offer: The Suburban plus $850.......and you deliver the Suburban!

I've been working on this pattern design, and tweaking for a long time, trying to find what I consider the right mix for an Ultralight...

That's pretty darn sassy Chris!! I love it!! Do you remember what it's called.....that would make searching for it on Amazon a bunch...

This came up on my FaceBook feed. Thought it was pretty good.

If so, then you own something that can be a great help with "hand" sanding! This lupus stuff, has proven a challenge for many of the...

I gotta wonder if the OP is serious, and thinks this is a dog owner's forum? Or maybe a troll?? I wasn't going to respond in this...

Any "stock removal" damascus pattern (such as ladder....where you remove stock in order to create patter) can be easily erased by too...

I neglected to say anything about gluing, but was reminded when I read Chris's post. Always totally finish out the front of scales, or...

I don't use anything to cover blades, but just try to be mindful, cautious, and blow away swarf with compressed air as I go. Most...

i was getting that for a while. No matter how flat i got it when I sealed it, the foil pouch was blowing up like a balloon. I had been...

Because what I heat treat contains such a tiny percentage of stainless steel, I just use foil wrap.... I've been on the same roll for...

IMO.....Yes. The required hold times and ramp requirements for heat treating most Stainless steels make a digitally controlled oven a...