Doug Humbarger Well-Known Member Apr 2, 2011 #1 Is there a tutorial on how to inlet wire such as gold, silver or copper into handles? If so I couldn't fine it. :sad:
Is there a tutorial on how to inlet wire such as gold, silver or copper into handles? If so I couldn't fine it. :sad:
Ernie Swanson SASSY PINK LUUNCHBOX KNIFE MAKER Apr 2, 2011 #2 I have seen one somewhere(other site I believe) , I will see if I can find it!
Robert Mayo Well-Known Member Apr 3, 2011 #3 Here is one i have had bookmarked for a while. Bob http://www.blademag.com/article/silverwireinlaypartone http://www.blademag.com/article/silverwireinlayparttwo
Here is one i have had bookmarked for a while. Bob http://www.blademag.com/article/silverwireinlaypartone http://www.blademag.com/article/silverwireinlayparttwo
Doug Humbarger Well-Known Member Apr 3, 2011 #4 Thanks Bob. I wish those tutorials had photos of the little chisels & making them instead of just writing about making them.
Thanks Bob. I wish those tutorials had photos of the little chisels & making them instead of just writing about making them.
C cdent Well-Known Member Apr 3, 2011 #5 There's also an additional article on the ABS website (americanbladesmith) under 'techniques' that might help. Take care, Craig
There's also an additional article on the ABS website (americanbladesmith) under 'techniques' that might help. Take care, Craig
Doug Humbarger Well-Known Member Apr 7, 2011 #6 Thanks Craig! That ABS artical was just what I wanted.