lerman
Well-Known Member
Hello, there are alot of firsts for me in this project, it's my first flipper, my first bolster lock, my second liner lock made and my first time instaling ball bearings on a knife, i'm still not sure if i'll even be able to make it all work,
this is going to be a very long WIP, I'll only work on it in between order so it might take awhile to complete (if i'll manage to complete it)
started with 6mm thick Ti, i first bored the bearing pivot screw pockets
then i thined the liner part to 1.8mm
cutting the lock bar
blade is cut
fitting the marble CF scaled and back spacer
thanks for looking
this is going to be a very long WIP, I'll only work on it in between order so it might take awhile to complete (if i'll manage to complete it)
started with 6mm thick Ti, i first bored the bearing pivot screw pockets
then i thined the liner part to 1.8mm
cutting the lock bar
blade is cut
fitting the marble CF scaled and back spacer
thanks for looking
Last edited: