Freds Edge
Well-Known Member
Does anyone know if when anodizing Ti do you add to the dimension of the material ? I am building a folder that had an early lockup after anodizing the TI I lost the lockup.
Great input Brett!! I never even considered that.
Even then, hardened "locator pins" are a requirement in my book....mainly because if it has screws, and/or can be taken apart, the first thing a customer does.....is just that....takes it apart.
Thanks Brett!I'm not Ed, but . . .
On a frame lock, I use two spacers in the back that screws pass through with a locator pin between them. The locator pin is in the middle position, where the third screw was when I used three screws, before I found the advantage of a locator pin.
Both my locator pin and my stop pin are press fit into the reverse liner. They won't come out even if the knife is disassembled. The holes in the obverse liner are reamed a couple of thousandths larger, for a pass-through fit.