Stag Drop Point

B

Bearpawcustoms

Well-Known Member
Shipped this one yesterday
Model:JVK
Steel: 1/8" 154CM@RC61/62
Blade:Length 2 1/2" tip to plunge,flat ground,Mirror finish
Overall Length:6 7/8"
Bolsters: 416ss
Handle: Sambar Stag,Red liners,Mosiac Pins,SS lanyard sleeve
Sheath; RH,9/10oz leather,Handstiched and Wetformed
Thank You for looking and all comments are welcome





 
Nice knife and sheath Dave. I could see myself using something like that in the deer woods.
A very nice package for sure!

If I may be so bold, I would like to make a small suggestion. If you were to use an edge bevel tool...say a number 2 or perhaps 3 it would take your sheath from good to great. You did a very nice job and it looks really good. Beveling the edges will subtly make a big difference.

Just my 2 cents. Not meant to be offensive.
 
Last edited:
Eric,
Thank You,
That sheath has a beveled edge it just doesn't show up in the Photo because of the Black Edge Dressing.
The Edge is Beveled then it is Burnished with a hardwood dowel in my drill press useing gum tacamouth and the the edge dressin applied.
Lagrange said:
Nice knife and sheath Dave. I could see myself using something like that in the deer woods.
A very nice package for sure!

If I may be so bold, I would like to make a small suggestion. If you were to use an edge bevel tool...say a number 2 or perhaps 3 it would take your sheath from good to great. You did a very nice job and it looks really good. Beveling the edges will subtly make a big difference.

Just my 2 cents. Not meant to be offensive.
Click to expand...
 
You must log in or register to reply here.
Back
Top