Slipjoint #2

[jkf96a]

Here's the second folding knife I've done. It's a linerless slipjoint, with bronze washers, brass pins, and 1/8" orange G10. The blade and spring are 1/8" 1080. Dimensions are 4 1/4 closed, 8 3/8 open, 3 1/2 blade. Has a hand sanded 600 grit finish and hand filed swedges.

Improved over #1 in terms of fitup. Pivot was wobbly a little on #1, nice and tight on this one. Added swedges to #2.

 

[Travis Fry]

nice nail nick. remind me again how you did it? you realize of course that I'm going to have to make one now?

 

[jkf96a]

Dremel cutting disc chucked in my drill press. Raised the table up to where I could keep the spine on the table. Did the depth and length freehand.

 

[Pieter]

I like it a lot.

 

[SBuzek]

Nice job Jason.
Stan