Michael Kemp
Well-Known Member
I'm building my 2nd propane forge - this one's more for forge welding - and I asked the folks at Omega what they'd recommend, given the temp range for forge welding. They came back with these:
http://www.omega.com/pptst/DPi_Series.html
http://www.omega.com/pptst/RAT_SAT_BAT.html
which add up to half a grand - more than I'm spending on the rest of the forge!
Unless there are good alternatives I'll just keep using ceramic cones! Figure if cone 5 bends I'm into the zone - if cone 8 starts to go, turn down the flame:
http://www.bigceramicstore.com/information/ConeChart.html
Any other suggestions?
http://www.omega.com/pptst/DPi_Series.html
http://www.omega.com/pptst/RAT_SAT_BAT.html
which add up to half a grand - more than I'm spending on the rest of the forge!
Unless there are good alternatives I'll just keep using ceramic cones! Figure if cone 5 bends I'm into the zone - if cone 8 starts to go, turn down the flame:
http://www.bigceramicstore.com/information/ConeChart.html
Any other suggestions?