O1 and Ironwood

[PetrifiedWood]

I made this knife for a friend who was visiting for a few days. In the process, I had him do a lot of the grunt work and I touched it up and smoothed out the finer details. I'm still learning, but I was able to use this build to do a little teaching as well.

I used 3/16" O1, white liners, brass hardware, and ironwood scales. He wanted the grip left fat so I didn't thin the scales as much I would were I making the knife for myself.

Thanks for looking!

 

[Keith Willis]

Looks good,should do the job.

God bless,Keith

 

[PetrifiedWood]

Thanks!

I see you're in Tylertown. I actually did some oil and gas title work in Walthall county for a couple of months there a few years ago. I remember eating at May's restaurant. Pretty good lunch buffet!

 

[UncleBillyKnives]

Very nice.

 

[BruceM]

Nice looking knife, looks like a stout one.

 

[Rob Nelson]

That's a pretty knife!

 

[Bush Monkey]

Very clean design. 01 and ironwood are hard to beat.

 

[franklin]

good on you thats looks really nice i'm sure he"ll have that by his side for a long time.

 

[Billy Helton]

Looks like fine work brother