BRad704
Well-Known Member
I have seen some knives that I really really like, that used micarta pins. Is that something you guys are making? or buying?
I don't even know how I would go about making it if I wanted to... Perhaps cutting a 1/4" wide strip off of a 1/4" thick piece, then spinning it in the drill press until its round. :les:
Can anyone give me some insight on this?
-Brad-
I don't even know how I would go about making it if I wanted to... Perhaps cutting a 1/4" wide strip off of a 1/4" thick piece, then spinning it in the drill press until its round. :les:
Can anyone give me some insight on this?
-Brad-